Chairs created from cane are exquisite furnishings for any home. You may see cane seat rockers in the nursery or cane woven love seats in a sunporch decked out with tropical wall art and fish wall hangings.

If you need to mend a hand-caned chair, you should take it to a master craftsman. Fortunately, you can repair machine-woven caning troubles including drooping cane or a seat replacement.
But your machine-woven cane seating can effortlessly be restored at home, whether the problem is a loose seat or if you need to exchange the seat entirely. An easily replaceable slat binds machine-woven cane together. If a chair is sagging, you often can repair if without even removing the spline or exchanging the caning. The following info will help you find what kind of repair your can chair necessitates.

Drooping Seat Troubles
A cane chair will sag down with recurring use, especially if the chair happens to be wet. But don't worry; this is an easy mend. Start by turning the chair over. Then you will have to rub down the caning of the chair with a damp cloth, taking caution to avoid getting the frame wet. Let the cane dry for a minimal of 24 hours, so the material can contract. In order to preclude further drooping, spray the chair with a mist of moisture every month and let it dry before using it once more. This will likewise guard against cracking and drying of the cane.

Whole Seat Replacement
Cane that has been machine-woven is bound to a frame with slat, like to window screen. It can likewise be replaced if need be. Look for a rut on the frame of the chair, which is filled with wood slat. In order to mend the seat, you want to take out the spline and exchange it.

Make certain you have plenty of cane to make the repair. Have enough to encompass the seat plus two more inches on each side. You can get sheets of cane at any wood or major craft retailer; they come in sheets 12 and 24 inches wide. In addition to the cane, you will need caning spline, a mallet, utility knife, wedges, flathead screwdriver, pair of scissors, wood glue, fine-grit sandpaper, and measuring tape. Also have a sink or a tub of warm water and a towel close by.

To begin, you need to take measurements of the seat of the chair and cut the caning so it will have two inches extra on each side. Soak the cane in the tub of tepid water for approximately 45 minutes until it is flexible. As the cane soaks, you can work on taking away the old material from the seat. You will require the flathead screwdriver to pry up the slat. The utility knife can also be employed to cut about the edges of the material if it is tough to get rid of. Be certain that all glue and dirt is taken from the grooves of the chair as well.
    * After making sure that the new wicker is malleable, take it out of the water and pat dry with a towel. Place the cane over the seat and use a wedge and mallet to tap it into the rut in the chair. Pull the wicker tight but be certain not to twist the caning. Then tap a wedge into the opposite side. Place additional wedges around the perimeter of the chair frame.
    * After you have placed wedges all about the chair, take them out one at a time. As you remove the wedges paste the new spline in. If you need to, use both the wedge and hammer to put the slat into the groove. Once the spline has been put in, cut it to fit and position the remaining part into position. Wait till the paste dries before clipping off surplus paste and material using the blade. Sand the area with the sand paper. A vacuum cleaner will take away all the debris. Then supply a coat of spray varnish to the new wickerwork.

Other Home Improvement Articles:
Tile can Add Big Style to a Small Bathroom
Garden Inspired Bedroom Retreat
How to Decorate a Kitchen with Creamy Glazed Cabinets
 


Comments




Leave a Reply